Browsing Mechanical Engineering by Journal
Now showing items 1-2 of 2
In situ fabrication of carbon fibre–reinforced polymer composites with embedded piezoelectrics for inspection and energy harvesting applicationsCurrent in situ damage detection of fibre-reinforced composites typically uses sensors which are attached to the structure. This may make periodic inspection difficult for complex part geometries or in locations which are difficult to reach. To overcome these limitations, we examine the use of piezoelectric materials in the form of macro-fibre composites that are embedded into carbon fibre–reinforced polymer composites. Such a multi-material system can provide an in situ ability for damage detection, sensing or energy harvesting. In this work, the piezoelectric devices are embedded between the carbon fibre prepreg, and heat treated at elevated temperatures, enabling complete integration of the piezoelectric element into the structure. The impact of processing temperature on the properties of the macro-fibre composites are assessed, in particular with respect to the Curie temperature of the embedded ferroelectric. The mechanical properties of the carbon fibre–reinforced polymer composites are evaluated to assess the impact of the piezoelectric on tensile strength. The performance of the embedded piezoelectric devices to transmit and receive ultrasonic signals is evaluated, along with the potential to harvest power from mechanical strain for self-powered systems. Such an approach provides a route to create multi-functional materials.
Piezoelectric vibration energy harvesting: A connection configuration scheme to increase operational range and output powerFor a conventional monolithic piezoelectric transducer (PT) using a full-bridge rectifier, there is a threshold voltage that the open-circuit voltage measured across the PT must attain prior to any transfer of energy to the storage capacitor at the output of the rectifier. This threshold voltage usually depends on the voltage of the storage capacitor and the forward voltage drop of diodes. This article presents a scheme of splitting the electrode of a monolithic piezoelectric vibration energy harvester into multiple (n) equal regions connected in series in order to provide a wider operating voltage range and higher output power while using a full-bridge rectifier as the interface circuit. The performance of different series stage numbers has been theoretically studied and experimentally validated. The number of series stages (n≥1n≥1) can be predefined for a particular implementation, which depends on the specified operating conditions, to achieve optimal performance. This enables the system to attain comparable performance compared to active interface circuits under an increased input range while no additional active circuits are required and the system is comparatively less affected by synchronized switching damping effect.