Among the various methods of extracting energy harvested by a piezoelectric vibration energy harvester, full-bridge rectifiers (FBR) are widely employed due to its simplicity and stability. However, its efficiency and operational range are limited due to a threshold voltage that the open-circuit voltage generated from the piezoelectric transducer (PT) must attain prior to any energy extraction. This voltage linearly depends on the output voltage of the FBR and the forward voltage drop of diodes and the nature of the interface can significantly limit the amount of extracted energy under low excitation levels. In this paper, a passive scheme is proposed to split the electrode of a micromachined PT into multiple (n) equal regions, which are electrically connected in series. The power output from such a series connected MEMS PT allows for the generated voltage to readily overcome the threshold set by the FBR. Theoretical calculations have been performed in this paper to assess the performance for different series stages (n values) and the theory has been experimentally validated. The results show that a PT with more series stages (high n values) improves the efficiency of energy extraction relative to the case with fewer series-connected stages under weak excitation levels.

Energy harvesters withstanding high temperatures could provide potentially unlimited energy to sensor nodes placed in harsh environments, where manual maintenance is difficult and costly. Experimental results on a classical microcantilever show a 67% drop of the maximum power when the temperature is increased up to 160 °C. This decrease is investigated using a lumped-parameters model which takes into account variations in material parameters with temperature, damping increase and thermal stresses induced by mismatched thermal coefficients in a composite cantilever. The model allows a description of the maximum power evolution as a function of temperature and input acceleration. Simulation results further show that an increase in damping and the apparition of thermal stresses are contributing to the power drop at 59% and 13% respectively.

This paper reports on the theory and experimental verification of utilising air damping as a soft stopper mechanism for piezoelectric vibration energy harvesting to enhance shock resistance. Experiments to characterise device responsiveness under various vibration conditions were performed at different air pressure levels, and a dimensionless model was constructed with nonlinear damping terms included to model PVEH response. The relationship between the quadratic damping coefficient ζ n and air pressure is empirically established, and an optimal pressure level is calculated to trade off harvestable energy and device robustness for specific environmental conditions.